You had one job (and you did it wrong)

Comments · 1.8K

• IN

  @InheritanceMachining · 2 years ago · pinned

  Use code INHERITANCE50 to get 50% OFF your first Factor box plus 20% off your next month of orders at <a href="https://bit.ly/46UBG9G">https://bit.ly/46UBG9G</a>!

  101

• AA

  @Aaron_hindle · 2 years ago (edited)

  I feel like the &quot;manly grunt &amp; Hmm&quot; was definatly a wifey thing when edditing and im absolutely here for it. so funny to see it pop up

  2.4K

• SK

  @skaramicke · 2 years ago

  <a href="https://www.youtube.com/watch?v=KVyeMKf4k3c&amp;t=386">6:26</a> Pro trip for saving on cleaning liquid and time spent cleaning the cleaner vat; Put the stuff you&apos;re cleaning in plastic bags with a sane amount of cleaning solution, close them, and run them in distilled water. The vibrations pass trough almost anything but normal plastic bags especially well, and you&apos;ll have to wait a very long time before you need to change the distilled water in the vat.

  170

• LY

  @lysseax · 2 years ago

  Your wife editing your videos is the funniest cutest shit. She gets to put in little jokes and silly clips of you that we wouldn&apos;t see otherwise haha

  1K

• KE

  @kevinsmith9420 · 8 months ago

  Gotta love the space efficient placement of the lathe as demonstrated by the crossfeed travel clearance pocket in the wall.😂😂

  20

• GB

  @gbestwick · 2 years ago

  Small note. After cleaning things in an ultrasonic like that, you need to flush with spotlessly clean water afterwards, give them a spin, and do it again. Ultrasonics loosen particulate, not flush it. So, for it to be spotless you need to flush it.

  345

• RO

  @rogerbehrens4879 · 2 years ago

  The taper pin for the lead screw you made is actually a Taper Shear Pin and shouldn’t be hardened.

  75

• 15

  @150Gianluca · 2 years ago

  I like how when you get the spindle out, you&apos;re holding it out like someone showing off a fish they caught &quot;You see that there, that&apos;s a big one&quot;

  816

• NA

  @natesteiner5460 · 2 years ago

  Make sure that hardened taper pin you made wasn&apos;t originally a soft metal shear pin. &nbsp;A 6061 pin would fail before the apron gears sustained damage in the event of a crash.

  55

• TR

  @tristankoscheloriginal7161 · 2 years ago

  I would suggest replacing the tapered pin with one made from Aluminium. They are made to break when you crash the lathe so the leadscrew dosent break first. Where i work this happend before and its not fun!

  719

• PA

  @pauloalvesdesouza7911 · 2 years ago

  Ms Inheritance Machining was a great addition. Keep her as permanent part.

  16

• HA

  @hannahworks247 · 2 years ago

  <a href="https://www.youtube.com/watch?v=KVyeMKf4k3c&amp;t=1207">20:07</a> “super duper sensitive, don’t want to hurt its feelings” 😂😂😂😂😂😂😂😂 👍🏻👍🏻👍🏻👍🏻👍🏻

  354