Making an Automatic Centre Punch ll Punching Above Its Weight 💪

Comments · 12

• DA

  @davidangelo8902 · 2 years ago

  I like the finished punch! thanks for the explanation on how it works. I always wondered about that!

  3

• HO

  @homemadetools · 2 years ago

  Nice work; it came out well. We shared this video on our homemade tool forum last week 😎

  1

• AR

  @armageddontools · 1 year ago

  Automatic center punches were never invented for making deep markings in material.They are used for finding the center of the two cross lines made by scribe.Tip angle(60°) is different than angle on drill punch(90°)  which you use after to make mark bigger.

  2

• DO

  @DONJUILIO · 2 years ago

  Very cool project, That's an art piece once you make it yourself. I was not expecting this sort of project., but you very often move thru a very diverse sort of list. Always something new and different from your channel, that's probably why I like it so much. I also like the I'm making it I'm not sure how but I'm making it.  Keep up the good work...

  1

• DF

  @dfu1685 · 1 year ago

  Well done. I do not have a lathe so I have no reason to subscribe however, this was a very fun video to watch and your mission was accomplished artfully.

  1

• PE

  @Pearlybrook · 1 year ago

  Nice video! I felt the cheap die struggles in my soul. Not sure if this was your issue or not but for anyone else reading this if you're buying a set of cheap dies look for a short but fairly aggressive taper in one side of the thread cutters. My first set of cheap dies were technically rethreading dies that didn't have this taper so starting a thread from nothing with them was nearly impossible.

  1