Steam Bending Inwales and Thwart Risers into the Poulsbo Boat - Episode 9

Hey folks, welcome to Nomad Boat Building. I'm Mark Reuten, and we're picking up where we left off on the Poulsbo Boat Project. This week I'm getting the boat ready for planking by bending and fitting the inwales and thwart risers. There's a fair bit of tricky work involved here, especially around the stem and transom where the angles compound and there's a lot of shape going on. I’ll show you how I work out those angles using simple battens and templates, how I deal with steaming some pretty stubborn Douglas-fir, and how I make adjustments when things don't quite fit the first time. There are a few mistakes along the way too — which is pretty normal in a boat shop. The Poulsbo Boat is a modern cedar-strip version of a 1950s-era sport fishing boat originally built in Poulsbo, Washington by Roland Young using traditional carvel construction. I'm building this version with cedar strip construction, fibreglassed inside and out. The inwales and thwart risers will eventually be laminated into rigid longitudinal structures, but for now they're being bent into position so I can establish the shape before planking. If you're interested in wooden boat building, cedar-strip construction, steam bending, woodworking, and the practical problem-solving that goes into building a boat, follow along as this project takes shape. SUPPORT THE CHANNEL Join me on Patreon: Patreon: nomadboatbuilding Your support helps keep these boatbuilding videos coming. WEBSITE https://nomadboatbuilding.com/ INSTAGRAM @nomadboatbuilding WATCH THE FULL POULSBO BOAT SERIES Poulsbo Boat Project New episodes follow the build from the backbone and moulds through planking, fibreglassing, interior work and eventually finishing the boat. CHAPTERS 0:00 Introduction 0:21 Week eight: getting back to work 0:30 Troubleshooting the stem bevel 1:01 Using plywood to check complex bevels 2:01 Preparing the backbone for planking 3:21 Installing the inwales before planking 4:18 Laminating the inwales in place 5:12 Working out the inwale angles 7:06 Solving the compound angle 8:16 Fitting the first inwale 8:47 Steam bending the inwales 11:38 Bending Douglas-fir 12:34 Cutting the compound mitres 16:23 Steaming the second bend 18:40 Fitting and adjusting the inwale 20:30 Steam bending Douglas-fir 23:08 Correcting the inwale angle 23:37 Transferring the transom angles 26:34 Adjusting the fit 27:37 Preparing the thwart risers 30:46 Correcting the mould reductions 34:28 Setting the laminations in place 35:47 Ready for lamination 36:03 Next episode #NomadBoatBuilding #PoulsboBoat #BoatBuilding #WoodenBoat #WoodenBoatBuilding #CedarStripBoat #StripBuiltBoat #SteamBending #Woodworking #Boatbuilding